Westinghouse WVE616SC User Manual

The Westinghouse WVE616SC is a 6.1 cubic foot top load washing machine with 12 wash cycles, 5 wash/rinse temperature combinations, 3 soil level settings, and a stainless steel wash basket. It features an LED display, delay start, child lock, and end-of-cycle signal. Powered by 120V AC, 60Hz. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Water Supply 7. Using Wash Cycles 8. Special Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Stainless steel wash basket, LED control panel, detergent dispenser, lint filter, adjustable leveling legs, water inlet hoses.

Feature	Description
Wash Cycles	12 cycles including Normal, Heavy Duty, Delicates, Quick Wash, and Bulky Items
Temperature Settings	5 combinations for wash and rinse (Hot/Cold, Warm/Cold, Cold/Cold, etc.)
Soil Level	3 settings: Light, Normal, Heavy
LED Display	Shows cycle time, settings, and status
Delay Start	Program start time up to 24 hours in advance
Child Lock	Locks control panel to prevent accidental changes
End-of-Cycle Signal	Audible alert when cycle completes
Detergent Dispenser	Separate compartments for detergent, bleach, and fabric softener
Lint Filter	Removable filter for easy cleaning
Adjustable Legs	Four leveling legs for stability

Installation

Unpack and inspect contents. Place on level floor near water supply and drain.

Remove shipping materials: Remove transit bolts and packing materials from drum.
Connect water supply: Attach hot and cold water hoses to corresponding faucets (red for hot, blue for cold).
Connect drain hose: Place drain hose into standpipe or laundry sink (minimum height 39 inches).
Level the washer: Adjust the four leveling legs until machine is stable and doesn't rock.
Plug into grounded 120V AC outlet.

WARNING! Washer is heavy; use two people for moving. Ensure all connections are secure to prevent leaks.

First-Time Setup

Power on washer; run initial test cycle.

Add detergent: Pour 1/2 cup of liquid detergent into detergent dispenser.
Select test cycle: Choose "Clean Washer" cycle or "Normal" cycle with hot water.
Start cycle: Press START/PAUSE to begin initial cleaning cycle.
Verify operation: Check for leaks during fill and spin cycles.
Set preferences: Configure end-of-cycle signal volume and default settings if available.

CAUTION! Do not load laundry during initial test cycle. Ensure washer is level before operation.

Specifications

Capacity: 6.1 cubic feet.
Dimensions: 27" W x 27" D x 43" H.
Voltage: 120V AC, 60Hz.
Water Connections: Hot and cold water inlet (3/4" standard hoses).
Max Spin Speed: 700 RPM.
Wash Cycles: 12 programmed cycles.
Control: Electronic with LED display.
Basket Material: Stainless steel.
Warranty: 1-year limited parts and labor.
Energy Star: Compliant for energy efficiency.

Controls and Settings

Access settings via control panel buttons and dial.

Control Panel: POWER, CYCLE SELECTOR dial, TEMPERATURE, SOIL LEVEL, OPTIONS (Delay Start, Extra Rinse, Pre-Wash), START/PAUSE, CHILD LOCK.

Cycle Selection: Turn dial to select from 12 cycles (Normal, Heavy Duty, Delicates, Quick Wash, Bulky, Bedding, Sanitize, etc.). Temperature: Select from 5 combinations (Hot/Hot, Warm/Cold, Cold/Cold, etc.). Soil Level: Light, Normal, Heavy. Options: Delay Start (1-24 hours), Extra Rinse, Pre-Wash. Display: Shows time remaining, selected settings, and error codes.

Connecting Water Supply

Hot and cold water connections required for full functionality.

Turn off water supply at faucets before connecting hoses.
Connect red hose to hot water faucet, blue hose to cold water faucet.
Hand-tighten connections; do not overtighten.
Turn on water supply and check for leaks at connections.
For drain: Ensure drain hose is secured in standpipe (not pushed in more than 6 inches).

Tip: Install drain hose support if using laundry sink. Keep hose loop higher than 39 inches to prevent siphoning.

Using Wash Cycles

Supports various fabric types and soil levels.

Load laundry: Do not overload; leave space at top of basket.
Add detergent: Use HE detergent; follow manufacturer's instructions for amount.
Select cycle: Turn dial to desired cycle (e.g., Normal for everyday items).
Set options: Choose temperature, soil level, and any additional options.
Start: Press START/PAUSE; machine will lock door and begin cycle.
Pause/Stop: Press START/PAUSE once to pause; press and hold to cancel cycle.
Unload: Wait for door lock to release (light goes off), then remove laundry promptly.

WARNING! Do not open door during wash or spin cycles. Balance load to prevent excessive vibration.

Special Features

Delay Start: Program wash to begin later (1-24 hours). Child Lock: Press and hold CHILD LOCK for 3 seconds to lock/unlock controls. Clean Washer Cycle: Run monthly with affresh® tablet or bleach to clean interior. End-of-Cycle Signal: Adjust volume or turn off in settings (if available).

Care & Cleaning

Unplug before cleaning exterior. Wipe control panel and exterior with damp cloth. Clean detergent dispenser monthly: Remove tray and rinse under warm water. Clean lint filter after every cycle: Remove, rinse, and replace. Run "Clean Washer" cycle monthly with washer cleaner.

CAUTION! Do not use abrasive cleaners or solvents. Keep area around washer dry to prevent slips.

Regulatory Information

UL Listed; complies with U.S. safety standards. Energy Star certified for energy efficiency. Copyright © Westinghouse; trademarks of Westinghouse Electric Corporation. For support, visit www.westinghouse.com or contact 1-800-947-3744.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Washer won't start	Door not closed/power	Ensure door is fully closed; check power outlet; press START/PAUSE firmly.
No water filling	Water supply/faucets	Check water supply is on; ensure hoses not kinked; verify faucets are open.
Excessive vibration	Unlevel/overload	Level washer using adjustable legs; redistribute load evenly.
Water leaks	Loose connections	Tighten hose connections; check drain hose is secure; inspect tub seal.
Poor cleaning	Detergent/loading	Use correct amount of HE detergent; do not overload; select appropriate cycle.
Error codes on display	Various faults	Consult manual for specific error code meaning; unplug for 5 minutes then retry.

Reset: Unplug for 5 minutes to reset electronic controls.

Service: 1-800-947-3744; www.westinghouse.com